Installing The Unit - Panasonic KX-TD816E Installation Manual

8.2.4 Installing the Unit

1. Loosen the two screws on the cover
plate. Insert your fingers into the slits
to remove the cover plate(s).
Slit
Note Any of the cover plates can be
removed as required.
2. Connect the cabinet cord of the 2-RF
Interface Unit with a 4-Station Line
(KX-TD144) to the connector in the
main unit firmly.
The following procedures can be used to install a 2-RF Interface
Unit with a 4-Station Line (KX-TD144) to the main unit, and then
the Cell Station (KX-TD142) to the KX-TD144.
The KX-TD1232 is illustrated as the main unit.
Slit
3. Hook the cabinet on the main unit and slide
the cabinet to the left until it is secured.
4. Loosen the outside screw and slide the
cover to the right.
5. Secure the inside screw (included) to
fix the cabinet to the main unit.
Note Be sure to fix the inside screw to the
main unit, or the unit may not work
properly.
DECT Portable Station Section
Outside screw
Inside screw
8-11