Panasonic KX-TD816E Installation Manual page 188

L
Note:
The 'X' and 'Y' in the
following program
addresses substitute:
X=carrier number 1-8
Y=table number 1-8
3-80 Features
(4) Automatic Access CO Line Group Assignment (Program
[103])
Usually this table is used for automatic line access in non-LCR
mode. In LCR mode, if the system cannot find out the dialled
number in Carrier Access Tables or LCR Routing Plan Tables, or
if the system finds out the same number as the user-dialled number
in Emergency Dial Number Set table or LCR Exceptional Code Set
table, this table is used to select a CO.
Automatic access CO line group table
Priority
CO line group 1
Carrier Access Tables
(1) LCR Carrier Code (Program [7X21])
This is used to store each carrier's access code. Example: Mercury
Communications Line (MCL)=131. If the system finds out the
same number as the user-dialled number in this table, the call is
sent to the carrier's line selected from the LCR CO Line Group
Assignment table (Program [7X23]).
(2)LCR CO Line Group Assignment (Program [7X23])
This program is used to assign CO lines available to access each
carrier.
LCR Routing Plan Tables
(1) LCR Leading Digit Entry for Plans 1– 8 (Program [7X0Y])
The user-dialled area code is compared with this table. If the
system finds out the same number in the table, a corresponding
LCR Time and Fee Set table (Program [7X1Y]) is applied to the
call.
(2) LCR Time and Fee Set (Program 7X1Y)
This table is used to register each carrier's fee in pounds per minute
in each time zone. The system compares the current time and each
carrier's charge fee by this table in order to decide the least
expensive carrier.
3 Features
1 2 3 4 5 6
2 3 4 5 6
7 8
7 8