Diagnostics And Special Settings; Enable/Disable Timeclock; Enable/Disable Ir Receiver; Enable/Disable Backlighting - Lutron Electronics GRAFIK Eye QSGRJ-3P Installation And Operation Manual

Diagnostics and Special Settings

Enable/Disable Timeclock

The timeclock can be enabled or disabled as desired.
1. Enter programming mode (see page 15),
Timeclock
select "Timeclock," and select "Enable/
Disable". Press the OK button to accept.
Monday
Enabled
2. Use the Master buttons to highlight either
"Enabled" or "Disabled". Press the OK
button to accept.
3. The info screen will confirm that your setting
has been saved.
Saved
4. Exit programming mode (see page 15).

Enable/Disable IR Receiver

The IR receiver can be enabled or disabled as desired.
1. Enter programming mode (see page 15) and
IR receiver
select "IR receiver". Press the OK button to
accept.
Monday
Disabled
2. Use the Master buttons to highlight either
"Enabled" or "Disabled". Press the OK
button to accept.
3. The info screen will confirm that your setting
has been saved.
Saved
4. Exit programming mode (see page 15).
®
1 2 3 4 5

Enable/Disable Backlighting

The backlighting on the info screen can be enabled or
disabled as desired.
Backlighting
Monday

Diagnostics

If you are having trouble with your control unit and call
Lutron Technical Support, you may be asked for diagnostic
information about your unit.
Diagnostics
Device SN
Link Info
6
1. Enter programming mode (see page
15) and select "Backlighting". Press
the OK button to accept.
Enabled
2. Use the Master buttons to highlight
either "Enabled" or "Disabled".
Press the OK button to accept.
3. The info screen will confirm that
your setting has been saved.
Saved
4. Exit programming mode (see page
15).
1. Enter programming mode (see page
15) and select "Diagnostics". Press
the OK button to accept.
2. Use the Master buttons to highlight
the option that will display the
required information. The info
screen can display the device serial
number, link information, code
version, or USB status. There is
Link info
also an option to reset the USB
connection (do this only if asked to
by Lutron Technical Support).
4. Exit programming mode (see page
15).
GRAFIK Eye QS Installation and Operation Guide 50
®
Master
buttons
OK
OK
button