Afterhours Mode - Lutron Electronics GRAFIK Eye QSGRJ-3P Installation And Operation Manual

Timeclock Operation

Afterhours Mode

Afterhours Mode is an advanced power-saving feature. It allows occupants to manually
turn on lights, but automatically turns the lights off after a specified amount of time
(Delay time). Before turning off, the lights can be set to flash to warn occupants, giving
them the opportunity to extend the time until Afterhours Mode is activated by pressing
a button on the GRAFIK Eye QS or on any associated wallstation. Afterhours Mode can
be started and stopped by Timeclock events (see page 37).
Afterhours Settings include:
Flash count: How many times the lights will dim and brighten (for dimmable loads) or turn on and off (for non-dim loads) to warn the
occupants the lights will be going to the Afterhours Scene (default 3 flashes).
Delay time: How long the system will wait from the end of the Flash Count until the lights go to the Afterhours Scene (default 15
minutes).
Warn time: How long the system will wait after a button is pressed on the GRAFIK Eye QS or on any associated wallstation (or the
space is occupied) to warn the occupants that the lights will be going to the Afterhours Scene and restart the Delay Time countdown
(default 5 minutes).
Afterhours Scene: Set by the user, the scene the lights will go to when Afterhours Mode is enabled (default scene is Scene 5).
Afterhours also has three modes to choose from:
Enabled: The enabled mode walks the user through each of the above settings' screens (see the next page). The initial values shown
on the screens are the defaults; press OK to accept, or use the Master buttons to modify the values. A GRAFIK Eye in enabled mode
will also cause any other associated GRAFIK Eye on the link (if it is not in afterhours disabled mode) to go into afterhours mode. (See
page 49 for an explanation of association.)
Disabled: A GRAFIK Eye in disabled mode will not send any of the loads it controls into Afterhours Mode, even if set as a timeclock
event or asked to by another GRAFIK Eye on the link.
Follow: A GRAFIK Eye in follow mode has no afterhours settings of its own, but it will carry out the settings of another associated
GRAFIK Eye on the link that goes into afterhours mode.
A B
Delay Afterhours
Time
C
Warn
Time
®
1
D
Delay
Time
E F G
Warn Delay
Time Time
2 3 4 5 6
Afterhours Example
H
A: Timeclock initiates start of afterhours mode.
Lights flash and Delay Time begins
B: Delay Time ends and Afterhours scene is activated
C: User presses a button to override Afterhours and keep lights on
D: Lights flash and Delay Time begins
E: User presses a button to override Afterhours and keep lights on
F: Lights flash and Delay Time begins
G: Delay Time ends and Afterhours scene is activated
H: Timeclock ends Afterhours mode
GRAFIK Eye
OK
(continued on the next page)
QS Installation and Operation Guide 41
®
Master
buttons
OK
button