Set Save Mode; Save Modes - Lutron Electronics GRAFIK Eye QSGRJ-3P Installation And Operation Manual

Set Save Mode

1. Enter programming mode (see page 15).
Main menu
2. Use the Master buttons to highlight "Save mode" and press
Scene setup
the OK button to accept.
Save mode
3. Use the Master buttons to highlight the save mode you would
like. The save modes are listed and explained below.
4. Press the OK button to accept. The info screen will confirm
Save mode
that your save mode has been saved.
5. Exit programming mode (see page 15).
Save always
Saved

Save Modes

Save by OK
(default mode)
Save always
Save never
Four scenes
(typically used for rented
spaces)
Button disable
(typically used in a public
space)
Note: Scene Off changes can only be saved through scene setup in programming mode (see page 31).
®
1 2
Quick scene programming mode; zone adjustments are temporary until the OK button is pressed
to confirm the selection
Automatically save changes made to lighting levels or fade time to Off (Master button changes are
temporary)
Do not save any temporary changes to lighting levels or fade time
Zone raise/lower buttons are disabled
Master raise/lower buttons, wallstations, and IR receiver are still enabled for adjustment of light
level, but these changes are not saved
Only the timeclock button, IR receiver, and wallstations can be used to make temporary changes
3 4 5 6
GRAFIK Eye
OK
QS Installation and Operation Guide 33
®
Master
buttons
OK
button