Completing Installation Of The Grafik Eye Qs - Lutron Electronics GRAFIK Eye QSGRJ-3P Installation And Operation Manual

Completing Installation of the GRAFIK Eye
1. Mount the control unit in the wallbox as
shown using the four screws pro vid ed.
Note: Follow all local and national
electrical codes when installing PELV
(Class 2: USA) wiring with line voltage/
mains wiring.
2. Verify installation:
• Restore power.
• Press the top scene button. The LED will
light.
• Press the zone raise or lower button.
Make sure the control unit is dimming all
connected loads.
3. Apply the protective overlay to the control
unit. See page 20 for instructions for
naming zones.
Protective overlay
(apply after installation)
®
QS
®
Note: When tightening mounting
screws, make sure that the hinged
cover and faceplate will open fully,
as shown.
GRAFIK Eye
7.9 in
(200 mm)
3.5 in
(87 mm)
3.75 in
(95 mm)
QS Installation and Operation Guide 11
®
Wall