Associating Sivoia; Qs Control Units - Lutron Electronics GRAFIK Eye QSGRJ-3P Installation And Operation Manual

Associating Sivoia

When a GRAFIK Eye QS system consists of Sivoia QS shades (or drapes) and a GRAFIK Eye QS with one
or more shade button groups, you can associate the shade button groups on the control unit with the
shades so the shade buttons can directly control the shades.
For Sivoia QS Shades wired directly to
the GRAFIK Eye QS control unit:
To associate or disassociate shades
with a shade button group:
1. On the GRAFIK Eye QS shade button
group you wish to assign shades to,
enter shade programming mode: Press
and hold the top (open) and bottom
(close) buttons simultaneously for 3
seconds. The top and bottom LEDs will
flash.
Shades that are unassigned will move to
up (open), and shades that are assigned
will move to close (down).
2. Tap the top (open) button to start
assigning.
3. Tap the top (open) button repeatedly to
cycle forward through the addresses;
tap the bottom (close) button to cycle
backward.
4. Press the shade group lower button to
associate the shade.
Press the shade group raise button to
disassociate the shade.
Lower button: Press to
associate
Raise button: Press to
disassociate
5. Exit shade programming mode: Press
and hold the top (open) and bottom
(close) buttons simultaneously for 3
seconds. The top and bottom LEDs will
stop flashing.
®
QS Shades/Drapes and GRAFIK Eye
®
For Wireless Sivoia QS Shades:
To associate shades with a shade button group:
1. Make sure the wireless mode of the GRAFIK Eye QS control
unit is "Enabled" (see page 16).
2. On the GRAFIK Eye QS shade button group you wish
to assign shades to, enter shade programming mode:
Press and hold the top (open) and bottom (close) buttons
simultaneously for 3 seconds. The top and bottom LEDs will
flash.
3. The LEDs on the electronic drive unit (EDU) and the wireless
antenna of unassociated shades/drapes will blink slowly. On
the shade/drape that you wish to associate with the shade
button group, tap any button; the LED on the EDU will blink
rapidly to indicate the shade is now associated with the
shade button group on the GRAFIK Eye QS.
4. Repeat step 2 to associate additional shades/drapes to that
shade button group.
5. Exit shade programming mode: Press and hold the top (open)
and bottom (close) buttons simultaneously for 3 seconds. The
top and bottom LEDs will stop flashing.
6. Repeat steps 1 through 5 for additional shade button groups,
as applicable.
To disassociate shades with a shade button group:
Repeat, in the same order, the steps above for associating
shades/drapes. When in shade programming mode, tap
any button on the electronic drive unit (EDU) of the shades/
drapes that you wish to disassociate from the shade button
group; the green LEDs on the EDU and antenna will blink
slowly to indicate the shade is disassociated from the shade
button group on the GRAFIK Eye QS.
Note: The wireless signal has a range of 30 feet (10 m)
through standard construction.

QS Control Units

®
GRAFIK Eye QS Installation and Operation Guide 45
®
1 2 3 4 5
Open
Preset
Close
Press and hold the top
(open) and bottom (close)
buttons on the GRAFIK
Eye QS shade button
group to enter or exit
shade programming mode.
LED
Sivoia QS Wireless
shade/drape EDU
6