Lutron Electronics GRAFIK Eye QSGRJ-3P Installation And Operation Manual page 6

Wiring the GRAFIK Eye
Step 4: Connect line voltage and loads
to control unit.
• Strip 5/16 inch (8 mm) of insulation off the
line voltage/mains cables in the wallbox.
5/16 inch
(8 mm)
• Connect the line voltage/mains, ground,
and load wires to the appropriate
terminals on the back of the control unit.
L: Hot/Live
N: Neutral
: Ground
Terminals 1-6: Dimmed/Switched
line voltage outputs
®
QS: Line Voltage Wiring Details (continued)
®
The recommended installation torque is
5.0 in∙lbs (0.6 N∙m) for line voltage/mains
connections and 5.0 in∙lbs (0.6 N∙m) for
the earth/ground connection.
Note: See page 18 for a list of
compatible load types and instructions
for programming the GRAFIK Eye QS to
properly recognize them.
Notice: Risk of damage to unit. GRAFIK Eye QS control units must be in stalled by a
qual i fied electrician in accordance with all applica ble reg u la tions and building codes.
Im prop er wiring can result in dam age to control units or oth er equipment.
Note: To avoid over heat ing and pos si ble damage to equipment, do not install control
units to dim re cep ta cles, mo tor-op erated ap pli ances, or flu o res cent lighting not
equipped with Lutron Hi-lume®, Eco-10®, or Tu-Wire® electronic dim ming ballasts, or
other devices approved for your location. In dimmed magnet ic low-voltage cir cuits, you
can pre vent trans former overheating and failure by avoid ing excessively high current
flow. Do not op erate control units with any lamps re moved or burned out; re place
any burned out lamps immediate ly; use only transform ers that in cor po rate ther mal
pro tection or fused pri ma ry wind ings. Control units are de signed for res i den tial and
commercial use, for indoor use only.
GRAFIK Eye QS Installation and Operation Guide 6
®