Scene Setup; And Shade Group Actions - Lutron Electronics GRAFIK Eye QSGRJ-3P Installation And Operation Manual

Scene Setup

Set Zone Levels, Fade Rates, and Shade Group Actions
1. Enter programming mode (see page 15).
Main menu
2. Use the Master buttons to highlight "Scene setup" and press
Timeclock
the OK button to accept.
Scene setup
3. Use the Master buttons to highlight "Levels" to adjust lighting
and/or shade levels. Press the OK button to accept. Use the
Master buttons to highlight the scene number of your desired
Scene setup
scene. Press the OK button to accept.
Levels
4. Set each zone to the desired light level for this scene using
Labels
the zone raise/lower buttons. The info screen will display the
zone and percentage as you adjust it.
To set a zone as unaffected, lower the light levels all the way
Scene setup
to off, then hold the zone lower button for 3 seconds. The
screen will display "---" and the three middle LEDs for the
zone will be lit to indicate this zone is unaffected by the scene
Scene 1
(the zone will not change when this scene is initiated).
When all zones are at the desired level, press the OK button to
accept.
Scene 1
5. Use the Master buttons to set the fade time for this scene.
Set zones
Press the OK button to accept.
6. Note: This step is applicable only if you have shades on your
3 seconds
system. If you do not have or do not wish to set shade groups
for this scene, press the OK button to skip this step.
Scene 1 Press the shade button that will take the shades assigned to
that button group to the level you want for this scene. Repeat
Adjust fade
for any additional shade button groups. Press the OK button
3
seconds
to accept. For shade programming, see pages 45 through 48.
7. The info screen will confirm that your scene has been saved.
8. Exit programming mode (see page 15).
Scene 1
Set shade
Groups
Saved
®
1 2 3 4 5 6
1 2 3
1 2 3
GRAFIK Eye QS Installation and Operation Guide 31
®
Master
buttons
OK
OK
button
4 5 6
Shade
button group
4 5 6
Zone raise
Zone lower