Scene Mode - Lutron Electronics GRAFIK Eye QSGRJ-3P Installation And Operation Manual

Occupancy Sensor Setup

Scene Mode

This step allows you to assign occupied and unoccupied scenes to up to four
occupancy sensors connected to the GRAFIK Eye
Select Sensors
Occ Sensor
1. If not already done, complete the steps on page 22, and
Setup
select "Scene Mode".
2. Use the Master buttons to highlight "Setup" and press the
Labels
OK button to accept. The screen will display "Searching" while
the unit detects available occupancy sensors.
3. Use the Master buttons to scroll through the list of available
occupancy sensors. When the desired sensor is displayed,
Saved
Searching
press the OK button to select it. Then choose "Assign" or
"Unassign" from the following menu and press OK. A screen
will verify your choice has been completed. Repeat for
additional sensors.
Sensor x/y
Set Sensor Action
SN: xxxx-xxxx 4. Press the Back button to return to the Occ Sensor screen.
Use the Master buttons to highlight "Actions" and press the
Source: RF 1/n
OK button to accept. By default, the occupied scene is set to
"No Action" and the unoccupied scene is set to "Scene Off".
5. Use the Master buttons to highlight the scene you wish to
Assignment
use for occupied status and press the OK button to accept.
Repeat for the scene you wish to use for unoccupied status.
Assign
Press the OK button to accept.
Unassign
6. Exit programming mode (see page 15).
Note: If wireless sensors are not found, verify that they are
Saved
*Assigned*
Occ Sensor
Actions
3 seconds
Setup
®
1
QS control unit.
®
associated correctly (see page 22).
Occupied Scene
Scene 1
2 3 4 5 6
Unoccupied Scene
Scene Off
GRAFIK Eye
OK
Saved
Saved
QS Installation and Operation Guide 24
®
Master
buttons
OK
button
Timeclock
(back) button