Zone Controller - Lutron Electronics GRAFIK Eye QSGRJ-3P Installation And Operation Manual

Associating Pico
®
To use the Pico wireless controller as a zone controller with a GRAFIK Eye QS Wireless control unit:
1. Make sure the wireless mode of the GRAFIK Eye QS control unit is "Enabled" (see page 16).
2. On the Pico, press and hold the top (on) and bottom (off) buttons for 3 seconds. The LED on the Pico
will flash slowly, and the scene buttons LEDs on the GRAFIK Eye QS will all flash.
3. On the GRAFIK Eye QS, the info screen will ask for confirmation that you wish to change the type;
press the OK button. Use the Master buttons on the GRAFIK Eye QS to select "Zone". Press OK to
save.
Pico
Change type?
Press OK
4. To assign a zone on the GRAFIK Eye QS to the Pico, use the zone raise/lower buttons for that zone to
set the desired preset level, then press and hold the zone raise and lower buttons simultaneously for 1
second (until the LEDs flash at the programmed preset level).
To unassign a zone on the GRAFIK Eye QS to the Pico, while the zone LEDs are flashing, press and
hold the zone raise and lower buttons simultaneously for 1 second (until the LEDs stop flashing and
the 3 middle LEDs light).
Repeat this step to assign levels for all desired zones to the Pico control. Zones assigned to the Pico
will have all LEDs flashing in unison, and zones not assigned will have the 3 middle LEDs lit.
5. On the Pico, press and hold the top (on) and bottom (off) buttons for 3 seconds. The LED on the Pico
and the LEDs on associated GRAFIK Eye QS Wireless control units will stop flashing.
Functionality of the Pico control when programmed as a zone controller:
Light
Top button: All assigned zones go to 100%
On
Adjust
Center round button: All assigned zones go to the programmed preset level
Bottom button: All assigned zones go to Off
Off
Note: The wireless signal has a range of 30 feet (10 m) through standard construction.
®
Wireless Controls and GRAFIK Eye
Change type?
Saved
Zone
(Press and hold to save current levels on assigned zone as preset)
®
1 2 3
Saved
QS Wireless Control Units
4 5 6
GRAFIK Eye QS Installation and Operation Guide 44
®
Info
screen
OK
Associate
OR
Disassociate
On the GRAFIK Eye QS control
unit, press and hold the top
scene button for 3 seconds to
associate, or press and hold
the bottom scene button for 3
seconds to disassociate with
the Pico control.
Zone LEDs
1 2 3 4 5
Zone Raise
Zone Lower
6