Zone Mode - Lutron Electronics GRAFIK Eye QSGRJ-3P Installation And Operation Manual

Occupancy Sensor Setup

Zone Mode

This step allows you to assign occupied and unoccupied zone levels to up to four
occupancy sensors per zone connected to the GRAFIK Eye
can be added to more than one zone.
Select Sensors
Occ Sensor
1. If not already done, complete the steps on page 22, and
Setup select "Zone Mode".
2. Use the Master buttons to highlight "Setup" and press the
Labels
OK button to accept.
3. Use the Master buttons to highlight "Add/Modify" and press
the OK button to accept. Available sensors will be displayed.
Sensors
4. You can assign up to four sensors per zone, and a sensor can
Add/Modify be assigned to more than one zone. Use the Master buttons
to scroll through the sensors until the one you wish to assign
Remove
or unassign is highlighted, and press the OK button to select
it.
5. Use the zone raise and lower buttons for each zone to assign
Sensor x/y
or unassign the sensor to that zone. The zone raise button
SN: xxxx-xxxx
assigns the displayed sensor, and the zone lower button
unassigns it. Repeat for all desired sensors and press OK. A
Source: RF 1/n
screen will verify your settings have been saved.
Set Sensor Action
6. Press the Back button to return to the Occ Sensor screen.
Use the Master buttons to highlight "Actions" and press the
Saved
Searching
OK button to accept.
7. Use the zone raise and lower buttons to adjust each zone to
its desired occupied level and press the OK button to accept.
Press and hold the zone lower button to designate a zone as
unaffected by the sensor.
Sensor x/y
Repeat for the zone levels you wish to use for unoccupied
Select Zones
status. Press the OK button to accept.
to Assign
8. Exit programming mode (see page 15).
Note: If wireless sensors are not found, verify that they are
associated correctly (see page 22).
Occ Sensor
Actions
Setup
®
1
Occupied
Set Occupied
3 seconds
Level for zones
2 3 4 5 6
QS control unit. Sensors
®
Unoccupied
Set Unoccupied
Level for zones
GRAFIK Eye
OK
1 2 3 4
1 2 3
Zone raise
Zone lower
Saved Saved
QS Installation and Operation Guide 25
®
Master
buttons
OK
button
Timeclock
(back) button
5 6
4 5 6