Fip-P10 Residual Image - Epson AcuLaser CX11 Service Manual

EPSON AcuLaser CX11/CX11F

FIP-P10 Residual Image

Before starting troubleshooting, inspect the feed path of the printer paper. Check the
paper feed path for metal staples, paper clips, paper scraps, and other foreign matter.
Step Check
Check of repeated printing
1
Check the residual image
Is the customer printing lots of the same
images?
Check of the residual image.
2
Print out 30 pages of various images.
Did any residual images appear?
Check of contact between Photoconductor
3
Unit and frame
Are the contacts of Photoconductor Unit and
HOUSING ASSY-GUIDE AD dirty or
deformed?
TROUBLESHOOTING
Problems
A ghost image appears on the printout. An
image of the previous page or part of the
currently printing page lap over like a ghost.
ESS and possible parts that caused the error
Photoconductor Unit
HOUSING ASSY- GUIDE AD
2ND BTR ASSY
FUSER ASSY
ROS ASSY
MOT ASSY MAG
PWBA ESS
PWBA MCU
LV/HVPS
500 FEEDER ASSY OPTION
Yes No
Go to Step [2]. Go to Step [3].
Go to Step [3]. End of procedure
(Advise the
customer not to
print same image
in large quantities
at a time.)
Clean or replace Go to Step [4].
relevant parts.$
Step Check
Check after replacement of Photoconductor
4
Unit
Replace Photoconductor Unit.
Make a test print of the problem image.
Is the image printed normally?
Check of 2ND BTR ASSY
5
Remove 2ND BTR ASSY.
Is 2ND BTR ASSY normal without any dirt,
damage or wear?
Check of Heat Roll and Pressure Roll
6
Allow FUSER ASSY to cool down
W A R N I N G
before performing work.
Remove FUSER ASSY.
Turn the Gear by hand, and inspect Heat Roll
and Pressure Roll.
Are Heat Roll and Pressure Roll scratched or
dirty and damaged?
Printer
Yes
End of procedure Go to Step [5].
Go to Step [6].
(p.374)
Replace FUSER
ASSY. (p.415)
(p.415)
Revision B
No
Replace 2ND
BTR ASSY.
(p.374)
Replace "ESS and
possible parts that
caused the error".
265