Mechanical Components; High Temperature Assembly - Epson AcuLaser CX11 Service Manual

Mechanical Components

When servicing any driving assembly (e.g., gears), first turn the power off and unplug
the power cord. Then manually rotate the assembly.
W A R N I N G
Do not touch the driving part (e.g., gears) while the assembly
(printer) is operating.

High Temperature Assembly

When working with hot parts (FUSER etc.) make sure to turn the power off, unplug the
power cable, and leave the printer until it cools down sufficiently to work on it to
prevent burn injury.
W A R N I N G
As the inside of the printer is high-temperature state immediately
after the operation, leave it more than 30 minutes before working.
Caution Label
(Refer to "Caution Label About High-temperature
manuals4you.com manuals4you.com
Surface")
FUSER Unit
Leg_001_022RA