EPSON AcuLaser CX11/CX11F
4.2.4.11 SENSOR REGI
REMOVAL
1.
Remove FRAME ASSY-PH.
(p352)
2.
Remove MOTOR-PH.
(p362)
3.
Remove DRIVE ASSY-PH.
(p365)
4.
Unhook the three hooks fastening SENSOR REGI to FRAME ASSY-PH, down
ACTUATOR-REGI with your fingers press and remove SENSOR REGI.
5.
Disconnect connector (P/J102) from SENSOR REGI.
REINSTALLATION
1.
Connect connector (P/J102) to SENSOR REGI.
2.
Press down ACTUATOR-REGI with your fingers, match the hooks on SENSOR
REGI with the attachment position, and attach to FRAME ASSY-PH.
3.
Attach DRIVE ASSY-PH.
(p365)
4.
Attach MOTOR-PH.
(p362)
5.
Attach FRAME ASSY-PH.
(p352)
DISASSEMBLY AND ASSEMBLY
4)-1
Figure 4-53. Removal of SENSOR REGI
Printer
Revision B
4)-3
5)
4)-2
Leg_Sec03_065FB
361