Epson AcuLaser CX11 Service Manual page 458

EPSON AcuLaser CX11/CX11F
4.2.12.18 SWITCH FEEDER DOOR
Step numbers with [ ] in the figure indicate the step during
C A U T I O N
attachment.
REMOVAL
1. Remove CHUTE FDR ASSY 500.
2. Remove COVER LEFT 500. (p449)
3. Remove the screw (silver, tapping, 8 mm) fastening CAP FEEDER to 500 PAPER
FEEDER ASSY.
4. Remove CAP FEEDER from 500 PAPER FEEDER ASSY.
5. Unhook the 2 hooks fastening SWITCH FEEDER DOOR to 500 PAPER
FEEDER ASSY, and remove SWITCH FEEDER DOOR.
6. Disconnect connector (P/J121) from SWITCH FEEDER DOOR.
REINSTALLATION
1. Connect connector (P/J121) to SWITCH FEEDER DOOR.
2. Match the hook on SWITCH FEEDER DOOR with the attachment position, and
attach to 500 PAPER FEEDER ASSY.
3. Pull the harness of the connector on SWITCH FEEDER DOOR from the outside
of 500 PAPER FEEDER ASSY, and take up any slack from the harness on the
SWITCH FEEDER DOOR side.
4. Match the boss on CAP FEEDER with the hole on 500 PAPER FEEDER ASSY,
and attach CAP FEEDER.
5. Fasten CAP FEEDER to 500 PAPER FEEDER ASSY with the screw (silver,
tapping, 8 mm).
6. Attach COVER LEFT 500. (p449)
7. Attach CHUTE FDR ASSY 500.
DISASSEMBLY AND ASSEMBLY
(p450)
(p450)
Table 4-25. Symptoms when the connector is loose
Connector
Panel Indication
No.
P/J121
G Open
6)
5)-2
Figure 4-137. Removal of SWITCH FEEDER DOOR
Printer
manuals4you.com manuals4you.com
Error Caused by Connector
Symptom
Disconnection
Printing using the 500-
sheet Cassette cannot be 500-sheet Cassette Rear
made. The main unit Cover is opened
prints normally.
5)-1
4)
3)
Leg_Sec03_028FA
Revision B
[3)]
460