Epson AcuLaser CX11 Service Manual page 515

EPSON AcuLaser CX11/CX11F
REINSTALLATION
1. Couple the FRAME COVER ASSY (NEUTRALIZING BRUSH attached side) to
the ADF FRAME UNIT positioning them as shown in
When attaching the TURNING ROLLER to the ADF FRAME
C H E C K
P O I N T UNIT, make sure to place the shaft of the TURNING ROLLER so
that one end of the shaft with D-shaped cross-section is at the right
side as shown in Figure
2. Insert the two STOPPER UPs of the EXIT ROLL ASSY into the holes of the
FRAME COVER ASSY as shown in
3. Secure the FRAME COVER ASSY to the ADF FRAME UNIT by inserting six
tabs of the FRAME COVER ASSY in the order shown in
4. Secure the FRAME COVER ASSY to the ADF FRAME UNIT with the two
screws (M3 x 8 mm, P-type, A-head). See
5. Attach the PAPER GUIDE R. (p515)
6. Attach the GUIDE FRONT ASSY.
7. Attach the MOTOR. (p509)
8. Attach the ADF BASE ASSY. (p498)
9. Attach the ADF COVER C. (p496)
10. Attach the PAPER GUIDE ASSY.
11. Attach the ADF COVER R. (p492)
12. Attach the ADF Unit. (p481)
13. Install the Scanner. (p306)
DISASSEMBLY AND ASSEMBLY
Figure 4-208.
4-209.
Figure 4-208.
Figure 4-209.
Figure 4-206.
(p511)
(p526)
NEUTRALIZING BRUSH Side
Figure 4-208. Reinstallation of FRAME COVER ASSY (1)
2)
ADF FRAME UNIT
EXIT ROLL ASSY
FRAME COVER ASSY
Figure 4-209. Reinstallation of FRAME COVER ASSY (2)
ADF Section
D-shaped Cross-section of
TURNING ROLLER Shaft
TURNING ROLLER
6
5
3
1
Revision B
STOPPER UP
2
4
517