Epson AcuLaser CX11 Service Manual page 328

EPSON AcuLaser CX11/CX11F
REINSTALLATION
When performing the following work, take care to prevent the
C A U T I O N
cable tie that bundles the harness of HARNESS-ASSY P/H 1
from being caught on the holes, etc. on the main unit.
When performing the following work, take care to prevent the
HARNESS-ASSY P/H 1 from being sandwiched between the
main unit and MSI ASSY.
1. Gently insert HARNESS-ASSY P/H 1 along the left side of MSI ASSY together
with MSI ASSY from the front of the main unit.
2. Insert MSI ASSY about halfway with the front of MSI ASSY lifted slightly to
avoid TIE PLATE under the main unit, and then bring out the connector of
HARNESS-ASSY P/H 1 from the hole on the main unit.
3. After matching MSI ASSY to the main unit attachment position, gently pull
HARNESS-ASSY P/H 1 from the outside to take up any slack inside the main
unit.
4. Fasten MSI ASSY to the main unit with the 6 screws (silver, with flange, tapping,
8 mm).
5. When a 500-sheet Cassette Unit is installed, turn the LOCK MC TO FDR 90
degrees to the opposite side of the arrow shown in Figure 4-24 to secure the 500-
sheet Cassette Unit to the main unit.
6. Connect connector (P/J408) and connector (P/J409) to PWBA MCU.
7. Fasten the harness of HARNESS-ASSY P/H 1 with the two clamps on CHASSIS
ESS.
8. Attach FRAME ASSY-PH. (p352)
9. Attach COVER FRONT L and COVER FRONT ASSY U.
10. Attach COVER MSI. (p317)
11. Attach COVER ASSY LH. (p321)
12. Attach COVER ASSY RH. (p326)
DISASSEMBLY AND ASSEMBLY
Connector No.
P/J408
P/J409
[3)]
CAUTION
(p318)
Printer
manuals4you.com manuals4you.com
Table 4-6. Symptoms when the connector is loose
Panel Indication Symptom
Printing is not
E Open
possible.
Printing is not
Service Req E547
possible.
[2)-1]
[2)-2]
Figure 4-25. Reinstallation of MSI ASSY
Revision B
Error Caused by Connector
Disconnection
---
Feeder Moter error
[1)]
Leg_Sec03_507EC
330