Drive Assy-Ph - Epson AcuLaser CX11 Service Manual

EPSON AcuLaser CX11/CX11F

4.2.4.15 DRIVE ASSY-PH

REMOVAL
1. Remove FRAME ASSY-PH. (p352)
2. Remove MOTOR-PH. (p362)
3. Unclamp the clamp on DRIVE ASSY-PH, and remove the harness.
4. Remove the 2 screws (silver, with flange, tapping, 8 mm) fastening DRIVE
ASSY-PH to FRAME ASSY-PH.
5. Remove DRIVE ASSY-PH from FRAME ASSY-PH.
REINSTALLATION
When performing the following work, make sure that the gears on
C A U T I O N
CLUTCH ASSY REGI and CLUTCH ASSY PRE REGI are
correctly engaged.
1. Match the hole on DRIVE ASSY-PH with the boss on FRAME ASSY-PH, and
attach DRIVE ASSY-PH.
2. Fasten DRIVE ASSY-PH to FRAME ASSY-PH with the 2 screws (silver, with
flange, tapping, 8 mm).
3. Fasten the harness with the clamp on DRIVE ASSY-PH.
4. Attach MOTOR-PH. (p362)
5. Attach FRAME ASSY-PH. (p352)
DISASSEMBLY AND ASSEMBLY
CLUTCH ASSY REGI
5)
4)
4)
Figure 4-57. Removal of DRIVE ASSY-PH
Printer
Revision B
3)
Leg_Sec03_069FA
CLUTCH ASSY PRE REGI
365