Controller Firmware Update - Epson AcuLaser CX11 Service Manual

EPSON AcuLaser CX11/CX11F

5.2.2.1 Controller Firmware Update

The procedure to update the controller firmware is given in the following table.
Procedure
Check the current Print a status sheet, and check the current firmware version. Print a status sheet, and check the current firmware version.
1
version.
Connect the printer to the computer with a USB cable.
Confirm that the "Ready" is displayed on the LCD.
Connect the printer with
2
the computer.
Turn the computer on and copy the program update file (the
3 Prepare the update data.
extension is RCC) onto the computer.
4 Start up the Printer.
Start up the Firmware Update Tool.Specify the port and the
5 Prepare to send the data.
program update file on the selection window of the tool.
Click [Send] on the Firmware Update Tool screen.
6 Transmit the data.
ADJUSTMENT
Table 5-3. Controller Firmware Update
Method 1
(RCC)
After turning the power off for both the printer and computer,
connect them with a USB cable.
C A U T I O N
Turn the computer on and copy the program update file (the
extension is CRB) onto the computer.
Turn the product ON while holding down the [Color Start],
[Reset], and [Down] buttons.The product will start up in
"Program ROM update" mode.
---
Start up the Firmware Update Tool.Specify the port and the
program update file on the selection window of the tool.
Click [Send] on the Firmware Update Tool screen.
Printer Section
Method 2
(CRB)
Before connecting the USB cable, make sure to
disconnect other interface cables from the
product.
Revision B
LCD Panel
---
---
---
Program Device
Version XX.XX
Please Send Data
---
Program Device
Version XX.XX
OLD: XXXX NEW: XXXX
535