Ir A Assy - Epson AcuLaser CX11 Service Manual

EPSON AcuLaser CX11/CX11F

4.3.3 IR A Assy

4.3.3.1 CCD MODULE ASSY
REMOVAL
1. Remove the Scanner. (p306)
2. Remove the ADF Unit. (p481)
3. Remove the IR COVER A ASSY.
4. Slide the PULLEY ASSY in the direction of an arrow shown in
release the tension of the IR TIMING BELT, and remove the IR TIMING BELT
from the pulley of the PULLEY ASSY.
5. Move the CCD MODULE ASSY to the center.
6. Turn the CCD MODULE ASSY upward upon the IR SHAFT, and hold it to
remove the two screws (M3 x 6 mm, B-type, P-head) that secure the FFC CR to
the CCD MODULE ASSY.
7. Disconnect the FFC CR from the connector on the CCD MODULE ASSY.
8. Release the left end of the IR SHAFT from the bearing of the IR BASE ASSY, and
remove the CCD MODULE ASSY together with the IR SHAFT.
9. Pull out the IR SHAFT from the CCD MODULE ASSY.
IR TIMING BELT
Figure 4-161. Releasing the Tension of IR TIMING BELT
DISASSEMBLY AND ASSEMBLY
(p482)
Figure 4-161
4)
PULLEY ASSY
CCD MODULE ASSY
5)
to
Figure 4-162. Removal of FFC CLIP
CCD MODULE ASSY
8)-1
Figure 4-163. Removal of CCD MODULE ASSY
Scanner Section
FFC CLIP
6)-1
6)-2
FFC CR
IR SHAFT
Revision B
8)-2
485