Epson AcuLaser CX11 Service Manual page 330

EPSON AcuLaser CX11/CX11F
REINSTALLATION
When performing the following work, attach with the retainer of
C A U T I O N
PAPER GUIDE facing down.
1. Insert the left side of the shaft on ROLL ASSY MSI into the left-side bearing of
MSI ASSY, and then slide ROLL ASSY MSI to the right and attach ROLL ASSY
MSI.
2. Match the notch of left and right BEARING MSI on ROLL ASSY MSI with the
positioning pin of SHAFT ASSY MSI, and insert BEARING MSI into the left and
right bearings of MSI ASSY to fasten ROLL ASSY MSI in place.
3. Match the notch of the left and right CAM PICK UP MSI on ROLL ASSY MSI
with the positioning pin of SHAFT ASSY MSI, and slide the left and right CAM
PICK UP MSI to the outside.
The notch of CAM PICK UP MSI must be properly matched with
C A U T I O N
the positioning pin of ROLL ASSY MSI.
4. Fasten the left and right CAM PICK UP MSI to SHAFT ASSY MSI with E-rings
When performing the following work, work can be performed more
C H E C K
P O I N T easily by turning ROLL ASSY MSI in the direction of the arrow to
release CAM PICK UP MSI and to set PLATE BOTTOM ASSY
MSI to a raised state.
DISASSEMBLY AND ASSEMBLY
When performing the following work, pay attention to the
C A U T I O N
attachment direction of SPRING-N/F MSI.
he oval side of the attachment section of SPRING-N/F MSI is
attached to BEARING MSI.
The semi-circular side of the attachment section of SPRING-N/
F MSI is attached to PLATE BOTTOM ASSY MSI.
5. Attach SPRING-N/F MSI to the left and right BEARING MSI.
6. Attach SOLENOID PICK UP.
7. Attach MSI ASSY. (p329)
8. Attach FRAME ASSY-PH.
9. Attach COVER FRONT L and COVER FRONT ASSY U.
10. Attach COVER MSI.
11. Attach COVER ASSY LH.
12. Attach COVER ASSY RH.
Printer
manuals4you.com manuals4you.com
(p344)
(p352)
(p317)
(p321)
(p326)
Revision B
(p318)
332