Cover Assy-Rr 2Nd - Epson AcuLaser CX11 Service Manual

EPSON AcuLaser CX11/CX11F
When HARNESS ASSY 2BTR SW need not be removed in the
C H E C K
P O I N T following procedure, COVER ASSY-RR 2ND can be removed
without removing COVER ASSY LH by disconnecting connector
(P/J113) from SWITCH 2BTR COVER instead of connector (P/
J621).

COVER ASSY-RR 2ND

4. Remove COVER ASSY LH. (p321)
5. Unclamp the clamp fastening the harness of COVER ASSY-RR 2ND, and remove
the harness.
When performing the following work, leave the intermediate
C A U T I O N
connector on the harness side.
6. Disconnect connector (P/J621) connected to the main unit, and insert the
connector inside through the hole on the main unit.
7. Remove the 2 screws (silver, with flange, 8 mm) fastening COVER ASSY-RR
2ND to the main unit.
8. Remove COVER ASSY-RR 2ND from the main unit.
DISASSEMBLY AND ASSEMBLY
7)
7)
8)
CHECK POINT
Figure 4-59. Removal of COVER ASSY-RR 2ND
Printer
Revision B
6)-1
5)
6)-2
Leg_Sec03_143RB
367