Fip-P16 Uneven Density/Thin-Spot; Connecting Location Of The Connectors - Epson AcuLaser CX11 Service Manual

EPSON AcuLaser CX11/CX11F

FIP-P16 Uneven Density/Thin-Spot

Before starting troubleshooting, inspect the feed path of the printer paper. Check the
paper feed path for metal staples, paper clips, paper scraps, and other foreign matter.
Step Check
Check the connectors for LV/HVPS.
1
Make sure that the connector (P/J504) on LV/
HVPS and the connector (P/J512) on 1st BTR
are connected properly.
Print the problem image. Or, execute the test
print.
Was the trouble fixed?
TROUBLESHOOTING
Problems
Uneven density/thin-spots appear on entire
surface. This occurs due to disconnection of
connector (D) from LV/HVPS.
ESS and possible parts that caused the error
WIRE ASSY BTR
LV/HVPS
Yes No
End of procedure Replace "ESS and
possible parts that
caused the error".

Connecting location of the connectors

Printer
Revision B
D
P/J512
(1BTR)
271