Switch Assy Fuser, Switch-Fuser Door - Epson AcuLaser CX11 Service Manual

EPSON AcuLaser CX11/CX11F

4.2.2.14 SWITCH ASSY FUSER, SWITCH-FUSER DOOR

REMOVAL
1. Remove COVER ASSY LH. (p321)
2. Open COVER FUSER.
3. Remove the two screws (silver, with flange, 8mm) that secure the COVER LEG
LH OUTER to the main unit, and remove the COVER LEG LH OUTER from the
main unit together with the HINGE COVER L.
4. Unclamp clamp fastening the harness of SWITCH ASSY FUSER and remove the
harness.
5. Remove the screw (silver, with flange, 8 mm) fastening SWITCH ASSY FUSER
to the main unit.
6. Remove SWITCH ASSY FUSER from the main unit.
When performing the following work, leave the intermediate
C A U T I O N
connector on the harness side.
7. Disconnect the connector (P/J117, blue) from the SWITCH ASSY FUSER.
8. Unhook the two hooks fastening the SWITCH-FUSER DOOR to BRACKET SW
FUSER, and remove the SWITCH-FUSER DOOR.
9. Disconnect the connector (P/J114) from the SWITCH-FUSER DOOR.
EINSTALLATION
1. Connect the connector (P/J114) to the SWITCH-FUSER DOOR.
2. Match the hooks on the SWITCH-FUSER DOOR with the attachment position,
and attach to the BRACKET SW FUSER.
3. Connect the connector (P/J117, blue) to the SWITCH ASSY FUSER.
4. Match the hole on the SWITCH ASSY FUSER with the boss on the main unit.
5. Fasten the SWITCH ASSY FUSER to the main unit with the screw (silver, with
flange, 8 mm).
6. Fasten the harness of the SWITCH ASSY FUSER with the clamp.
DISASSEMBLY AND ASSEMBLY
7. Secure the COVER LEG LH OUTER with the two screws (silver, with flange, 8
mm) to the main unit together with the HINGE COVER L.
8. Close the COVER FUSER.
9. Attach COVER ASSY LH.
Table 4-5. Symptoms when the connector is loose
Connector No. Panel Indication
P/J114 C Open
P/J117 C Open
5)
Figure 4-18. Removal of SWITCH ASSY FUSER and SWITCH-FUSER DOOR
Printer
(p321)
Error Caused by Connector
Symptom
Disconnection
Printing is not
possible.
Printing is not
possible.
3)-1
7)
7)
9)
8)-2
8)-1
Leg_Sec03_012RB
Revision B
---
---
3)-1
3)-2
6)
323