Drive Assy Pro - Epson AcuLaser CX11 Service Manual

EPSON AcuLaser CX11/CX11F

4.2.10.2 DRIVE ASSY PRO

REMOVAL
1. Remove COVER ASSY LH. (p321)
2. Remove OP PANEL. (p320)
3. Remove COVER INNER TOP.
4. Disconnect connector (P/J411,P/J414) from the PWBA MCU.
5. Unclamp the harness on DRIVE ASSY PRO on the left side of the main unit from
the clamp. If the harness is difficult to remove, remove PWBA MCU.
6. Remove the 4 screws (silver, with flange, 6 mm) fastening DRIVE ASSY PRO to
the main unit.
7. Remove DRIVE ASSY PRO from the main unit.
REINSTALLATION
1. Inset the motor section and harness on DRIVE ASSY PRO into the hole on the
main unit, match the hole on DRIVE ASSY PRO with the boss on the main unit,
and attach DRIVE ASSY PRO.
2. Fasten DRIVE ASSY PRO to the main unit with the 4 screws (silver, with flange,
6 mm).
3. Fasten the harness on DRIVE ASSY PRO with the clamp on the left side of the
main unit.
4. Connect connector (P/J411,P/J414) to the PWBA MCU.
5. Attach COVER INNER TOP. (p324)
6. Attach OP PANEL. (p320)
7. Attach COVER ASSY LH. (p321)
DISASSEMBLY AND ASSEMBLY
(p324)
(p432)
Printer
5)
Figure 4-104. Removal of DRIVE ASSY PRO
Revision B
7)
6)
6)
6)
6)
Leg_Sec03_099EA
421