4
Crimp both connector pins (A) using pliers to make them fit through the pin holes. Push the connector off its slot.
5
Route the interface cable off the drawer, and remove.
Note: Pay attention to the original routing of the cable.
Sensor (HCIT media low) with flag removal
1
Remove the HCIT. See
2
Remove the drawer assembly rear cover. See
3
Remove the drawer assembly left cover. See
4
Release the latches (A) securing the sensor to the drawer.
"HCIT removal" on page
423.
"HCIT drawer assembly rear cover removal" on page
"HCIT drawer assembly left cover removal" on page
Repair information
439
4063
428.
429.