Sensor Test; Diverter Test; Finisher Tests; Staple Test - Lexmark MS81x Service Manual

To run the Feed To All Bins test:
1
From the Diagnostics menu, navigate to: OUTPUT BIN TESTS > Feed to All Bins.
The printer feeds a separate piece of media to the standard bin first, then it feeds a separate piece of media to each
output bin installed in order.
The test continuously prints the Print test pages until X is pressed.
2
Press Back to return to the OUTPUT BIN TESTS menu.

Sensor Test

This test verifies that the output bin sensors are working correctly.
To run the Output Bin Sensor Test:
1
From the Diagnostics menu, navigate to:
Output Bin Tests > Sensor Test > Standard Bin or Output Bin Tests > Sensor Test > [Output bin #]
Testing... appears while the printer is verifying the state of the sensor.
The control panel displays the current state of the sensor.
2
Manually actuate the sensor to make it toggle between empty and full or between open and closed,
depending on the sensor. If the sensor does not toggle, then the sensor is malfunctioning.
3
Press X to exit the test.

Diverter Test

This test verifies that the mailbox option's output media diverters are working correctly. If more than one mailbox
option is installed, then this test exercises the diverters on all installed mailbox devices.
To run the Diverter Test:
1
From the Diagnostics menu, navigate to:
OUTPUT BIN TESTS > Diverter Test.
Diverter Test Testing... appears while the printer is verifying the state of the diverter.
2
Press X to exit the test.

FINISHER TESTS

Staple Test

This test verifies the operation of the staple mechanism in the finisher. The printer feeds eight pieces of media to the
finisher and accumulates all eight pieces in the finisher. After the last sheets are accumulated, the pack is stapled.
To run this test:
1
From the Diagnostics menu, navigate to:
Finisher Tests > Staple Test
2
Select the output bin, and press
Staple Test Running... appears while the test is running.
.
Service menus
233
4063