7
Pry the frame loose to release the pins (C).
8
To access the cable, lift the left side of the top plate, and pull the sensor assembly away from the drawer.
Note: Pay attention to the original routing of the cable.
9
Route the sensor cable off the drawer, and remove the sensor.
Sensor (pick) removal
1
Remove the media tray. See
2
Remove the rear cover. See
3
Remove the left cover. See
"250/550-sheet media tray and drawer assembly removal" on page
"Drawer assembly rear cover removal" on page
"Drawer assembly left cover removal" on page
Repair information
419
406.
409.
410.
4063