Hcoe Diverter Jam Service Check - Lexmark MS81x Service Manual

Action
Step 7
Re-seat the divert motor connector (J7) on the controller PCBA. POR the
machine.
Does the error remain?
Step 8
Re-seat all the connectors on the controller PCBA. POR the machine.
Does the error remain?

HCOE diverter jam service check

Action
Step 1
Is the high capacity output expander the only output option installed?
Step 2
Remove all output options and re-install only the high capacity output
expander.
Enter Diagnostics Menu and navigate to:
Output bin tests > Feed to all bins
Does the output option feed to all bins normally?
Step 3
Check the lower interface cable. If damaged, then replace the lower
interface cable. Go to "HCOE lower interface cable removal" on
page 469.
Re-seat the connector (J1) on the controller PCBA, then POR the machine.
Does the error remain?
Step 4
Check the auto connector end of the printer underneath the option.
Is it free of damage or obstructions?
Yes
Replace the divert
motor. Go to
divert motor removal"
on page
If the error persists,
then go to step 8.
Replace the controller
PCBA. Go to
controller PCBA
removal" on page
507.
If the error persists,
then replace the
mailbox assembly. Go
to
removal" on page
500.
Yes
Go to step 3.
The problem may not
be on this option tray.
Re‑install the
remaining output
options one at a time
and test each option
for errors. Proceed
with the appropriate
service check based on
the error message and
the output option
being tested.
Go to step 4.
Go to step 5.
Diagnostic information
175
No
The problem is solved.
"Mailbox
512.
The problem is solved.
"Mailbox
"Mailbox assembly
No
Go to step 2.
Go to step 3.
The problem is solved.
Replace the upper
interface cable of the
base printer.
4063