Wipe All Settings
This makes any sensitive information that may exist on the volatile or non-volatile storage of the device completely
indecipherable. When selected, the printer performs a non‑critical NVRAM reset and then reboots.
Font Sharpening
This setting allows a user to set a text point-size value below which the high‑frequency screens will be used when
printing font data.
To change the setting:
1
From the Configuration Menu, navigate to Font Sharpening.
2
To change the value, depending on the model, enter the numerical value or press the arrows, and then press
Submit.
3
Press Back or X to return to the Configuration menu.
Require Standby
Note: This setting is available on the touch screen models only.
This setting determines whether Standby Mode is On or Off. The default is On.
To change the setting:
1
From the Configuration Menu, navigate to Require Standby.
2
Select On or Off to change the setting.
3
Depending on the printer model, press OK or touch
Menu without saving any changes.
If Standby Mode is On, the printer begins functioning in Standby Mode when it remains idle for an amount of time.
The Standby Mode enables the printer:
•
To consume less energy than when operating in normal mode but not as little as when operating in Power Saver.
•
To return to the Ready state more quickly than when operating in Power Saver. If set to Off, this setting disables
Standby Mode in the General Settings Menu.
A5 Loading
This determines the orientation used when printing on A5 paper.
Available options:
•
Long Edge—The printer will print A5-size paper in the long-edge feed orientation from all trays.
•
Short Edge—The printer will print A5-size paper in the short-edge feed orientation from all trays.
to save the setting, or press X to return to the Configuration
Service menus
249
4063