Error Code Number Key; Power-On Reset (Por) Sequence; Power‑On Reset Sequence - Lexmark MS81x Service Manual

•
Make sure the paper is the recommended paper for this printer.
•
Make a trial print with paper from a newly opened package, and check the result.

Error code number key

The following chart identifies the error code numbers that should be consistent across product lines.
Range Description
0–99 User attendance messages
100–199 Printer hardware errors
200–299 Printer and input option paper jams
300-399 Input/output option hardware errors
400–499 Output option paper jams
400–403 HTU paper jam
431–432 Mailbox (x = bin number) paper jam
450–458 Finisher/Stacker paper jam
461 Hole Punch paper jam
900–999 Firmware and/or system electronics errors
Power‑on Reset (POR) sequence
When you turn the printer on, it performs a Power-on Reset (POR) sequence.
Check for correct POR functioning of the base printer by observing the following:
1
The LED turns on.
2
The main fan turns on.
3
The operator panel turns on.
4
The fuser heater turns on. The fuser takes longer to warm up from a cold start than a warm start.
5
The operator panel LED starts blinking.
6
A splash screen appears on the display. The following errors or messages may appear:
• Close Door or Insert Cartridge appear if the front access door is open or the print cartridge is missing
•
Cartridge errors, such as Defective Cartridge or Missing Cartridge
7
Ready appears on the display.
8
The main drive motor turns on.
9
The EP drive assembly drives the developer shaft located in the print cartridge.
Diagnostic information
36
Go to page
See "User attendance messages
(0-99.99)" on page 94.
See "Printer hardware errors
(100-199.99)" on page 101.
See "Paper jams" on page
See "Input/output option hardware
errors" on page 123.
See "Input/output option paper jam
errors" on page 143.
See "Firmware and/or system
electronics errors (900-999.99)" on
page 113.
4063
47.