Lexmark MS81x Service Manual page 164

Error code Description
424.01 Media remains detected by the output option 1/high
capacity output expander sensor (pass through) after
power on.
424.03 The media fed did not reach the output option 1/high
capacity output expander sensor (pass through).
424.05 The media while feeding remains detected by the
output option 1/high capacity output expander
sensor (pass through).
424.09 Never received Page In Output from output option
1/high capacity output expander
424.10 Invalid Page ID returned by output option 1/high
capacity output expander
424.41 Output option 1/high capacity output expander
main/interface motor stalled
424.42 Output option 1/high capacity output expander
main/interface motor did not reach the required
speed.
424.43 Took too long to ramp up main/interface motor in
output option 1/high capacity output expander
424.53 Output option 1/high capacity output expander
main/interface motor did not reach the required
speed.
424.71 Diverter failed to leave its home position on the
output option 1/high capacity output expander
424.72 Diverter failed to reach its home position on the
output option 1/high capacity output expander
427.01 Media remains detected by the output option 2/high
capacity output expander sensor (pass through) after
power on.
427.03 The media fed did not reach the output option 2/high
capacity output expander sensor (pass through).
427.05 The media while feeding remains detected by the
output option 2/high capacity output expander
sensor (pass through).
427.09 Never received Page In Output from output option
2/high capacity output expander
427.10 Invalid Page ID returned by output option 2/high
capacity output expander
Action
1
POR the printer.
2
Reseat all the installed output options on the
printer.
3
Clear obstructions along the paper path.
4
Make sure that the sensors (pass through) are
free from obstructions.
5
Close the rear door properly.
If the problem remains, then go to
pass through) jam service check" on page
1
POR the machine.
2
Reseat the output option on the printer.
3
Clear obstructions along the paper path.
4
Make sure the sensors (pass through) are free
from obstruction.
5
Close the rear door properly.
If the problem remains, then go to
service check" on page
1
POR the printer.
2
Reseat all the installed output options on the
printer.
3
Clear obstructions along the paper path.
4
Make sure that the sensors (pass through) are
free from obstructions.
5
Close the rear door properly.
If the problem remains, then go to
jam service check" on page
1
POR the printer.
2
Reseat all the installed output options on the
printer.
3
Clear obstructions along the paper path.
4
Make sure that the sensors (pass through) are
free from obstructions.
5
Close the rear door properly.
If the problem remains, then go to
pass through) jam service check" on page
Diagnostic information
164
4063
"Sensor (HCOE
177.
"HCOE failure
139.
"HCOE diverter
175.
"Sensor (HCOE
177.