5
Remove the screw (A) securing the sensor.
6
Release the cable from its cable holders, then remove the sensor (pass through).
HCIT media feeder removal
1
Remove the HCIT. See
2
Remove the drawer assembly rear cover. See
3
Remove the drawer assembly left cover. See
4
Remove the top cover assembly. See
5
Remove the sensor (roller position). See
"HCIT removal" on page
423.
"HCIT drawer assembly rear cover removal" on page
"HCIT drawer assembly left cover removal" on page
"HCIT top cover assembly removal" on page
"Sensor (pick roll position) removal" on page
Repair information
443
428.
429.
434.
440.
4063