Hcit Source Jam Service Check - Lexmark MS81x Service Manual

Action
Step 17
Check the sensor (HCIT roller position) and make sure that it is properly
installed. If damaged, then replace the sensor. Go to
position) removal" on page
Reseat the sensor connector on the controller PCBA and reseat also on
the other end of the sensor. POR the machine.
Does the error remain?
Step 18
Open the right cover. Reseat the cable attached to the lift motor.
Does the error remain?
Step 19
Open the right cover. Do a feed test, enter Diagnostics mode and navigate
to:
INPUT TRAY TESTS > Feed Test > Tray [x]
Does the lift motor run?
Step 20
Reseat all connectors on the controller PCBA.
Does the error remain?

HCIT source jam service check

Action
Step 1
Remove the media tray from the HCIT option and do the following:
• Remove all media and check the paper guides for damage. Move the
paper guide and verify if it can move freely from one position to
another.
• Check the media size finger flag for damage.
• Check the elevator plate. Manually lower down the elevator plate and
check if it springs back to its original position.
• Check the elevator tension cables if there are problems.
• Check the elevator gears for damage.
•
Manually turn the drive gear and check if the other gears engaged to
it will also turn.
•
Check if the tray can be inserted properly into the HCIT option.
Are the above components ok?
"Sensor (pick roll
440.
Diagnostic information
Yes
Go to step 18.
Go to step 19.
Go to step 20.
Replace the controller
PCBA. Go to
controller PCBA
removal" on page
433.
Yes
Go to step 2.
159
No
The problem is solved.
The problem is solved.
Replace the lift motor.
Go to "HCIT lift drive
motor removal" on
page 436.
The problem is solved.
"HCIT
No
Replace the media tray.
Go to "HCIT removal"
on page 423.
4063