Finisher Bin Media Present Error Service Check - Lexmark MS81x Service Manual

Action
Step 7
Check the compactor:
•
for proper installation
•
for damage and contamination
•
for cable damage
Is the above component ok?
Step 8
Remove the stapler carriage. Manually turn the gears to open the stapling
mechanism. While open, check the area under the stapling mechanism
and make sure it is free from obstructions.
Is it free of damage?
Step 9
Reseat all connectors on the controller PCBA.
Does the error remain?

Finisher bin media present error service check

Action
Step 1
Is the staple finisher the only output option installed?
Step 2
Remove all output options and re-install only the staple finisher.
Enter Diagnostics Menu and navigate to:
Output bin tests > Feed to all bins
Does the output option feed to all bins normally?
Yes
Go to step 8.
Go to step 9.
Replace the controller
PCBA. Go to
controller PCBA
removal" on page
496.
If the error persists,
then replace the staple
finisher. Go to
finisher assembly
removal" on page
471.
Yes
Go to step 4.
The problem may not
be on this option tray.
Re‑install the
remaining output
options one at a time
and test each option
for errors. Proceed
with the appropriate
service check based on
the error message and
the output option
being tested.
Diagnostic information
219
No
Replace the sensor
(compactor HP).
Replace the stapler
carriage assembly. Go
to "Stapler carriage
assembly removal" on
page 479.
The problem is solved.
"Stapler
"Staple
No
Go to step 2.
Go to step 3.
4063