Finisher Tray Holder Jam Service Check - Lexmark MS81x Service Manual

Finisher tray holder jam service check

Action
Step 1
Is the staple finisher the only output option installed?
Step 2
Remove all output options and re-install only the staple finisher.
Enter Diagnostics Menu and navigate to:
Output bin tests > Feed to all bins
Does the output option feed to all bins normally?
Step 3
Check the auto connector end of the option previously installed below the
staple finisher.
Is it free of damage?
Step 4
Check the lower interface cable. If damaged, then replace the lower
interface cable. Go to "Stapler lower interface cable removal" on
page 494.
Remove the left cover. Reseat the cable (J15) on the controller PCBA, then
POR the machine.
Does the error remain?
Step 5
Remove the left cover. Check and reseat the cables (J24 and J22) on the
controller PCBA. If damaged, then replace the staple finisher assembly.
Go to "Staple finisher assembly removal" on page
POR the machine.
Does the error remain?
Yes
Go to step 4.
Perform step 2 again
using the other
remaining output bins.
The problem may not
be on this option tray.
Re‑install the
remaining output
options one at a time
and test each option
for errors. Proceed
with the appropriate
service check based on
the error message and
the output option
being tested.
Go to step 4.
Go to step 5.
Go to step 6.
471.
Diagnostic information
188
4063
No
Go to step 2.
Go to step 3.
Replace the upper
interface cable of the
output option
previously installed
under the staple
finisher.
The problem is solved.
The problem is solved.