Error code Description
230.28
The sensor (duplex path) rebounded upon
being released by the trailing edge of the
media
Sensor (duplex path) static jam service check
Action
Step 1
Check the duplex path for jammed media.
Is the duplex path free from jammed media?
Step 2
Check the sensor (duplex path) for proper operation.
a
Enter the diagnostic mode.
b
Select duplex tests.
c
Select sensor test.
d
Observe the line item sensor.
Does the display on the control panel change every time the sensing area
of the above sensor is interrupted or blocked?
Step 3
Check the above sensor for proper connection.
Is the above sensor connected properly?
Step 4
Perform a print test.
Does the problem remain?
Action
See
"Sensor (duplex path) miscellaneous jam service check" on
page
77.
Yes
Go to step 2.
Go to
Replace the sensor
(duplex path). See
"Sensor (duplex path)
removal" on page
344.
Go to step 4.
Contact the next level
of technical support.
Diagnostic information
73
No
Remove any jammed
media.
step
4.
Go to step 3.
Reseat the connection.
Go to step 4.
Problem solved.
4063