Mailbox upper interface cable removal
1
Remove the top cover. See
2
Remove the mailbox left cover. See
3
Disconnect the upper interface cable (J1B) from the controller PCBA.
4
Crimp both connector pins, using pliers to make them fit the pin holes. Push the connector off its slot.
5
Remove the upper interface cable.
Mailbox divert motor removal
1
Remove the top cover. See
2
Remove the mailbox left cover. See
3
Disconnect the cable (A) from the divert motor.
"Mailbox top cover removal" on page
"Mailbox left cover removal" on page
"Mailbox top cover removal" on page
"Mailbox left cover removal" on page
Repair information
512
500,
506.
500.
506.
4063