Section C - Connecting The Input/Output Signals; Connecting The Video Inputs - Cisco D9054 Installation And Operation Manual

Section C - Connecting the Input/Output Signals

Connecting the Video Inputs

Connector for the Video Input
The video input connector is of the BNC type. The input signal is looped through to
the connector marked OUT.
The following video input signal is supported:
• 1.5 Gbit/s High Definition Serial Digital Interface (HD-SDI) according to SMPTE-
292M, with 1080i/25 Hz, 1080i/29.97 Hz, 720p/50 Hz or 720p/59.94 Hz.
Video Connector
The following table shows the video connector:
Connector
To Connect the Video Input
1. Connect the video input signal to the connector for video, labeled 292M IN.
There are 2 connectors to provide active loop-through possibility.
2. If required, connect the 292M OUT connector to a video monitor.
To Connect the Reference Input
Do as follows to connect to the reference input:
1. Connect the reference input signal to the REF IN connector.
Use a 75-ohm double-braided coax cable.
4038938 Rev A
Interface Type
SMPTE-292M
D9054 HDTV Encoder Intstallation and Operation Guide
Connector Type
BNC female
3-7