Section E - Power and General Specifications
Power
AC Power Connector
Type of connector
AC input
Power
Current
Power Quality
Introduction
The encoder is supplied with two power supplies that provide redundant power
with no single point of failure. Normal typical operation requires both supplies to be
powered up and switched on. Each power supply should be powered from a sepa-
rate mains branch circuit, in order to ensure redundancy.
The DC outputs from both power supplies are combined together in a current-
sharing scheme so that the total load is shared.
Power
To operate the encoder, you must connect it to an AC power source.
WARNING:
Make sure that at least one end of the power cable(s) remains easily accessible
for unplugging, if you need to switch off the unit. For example: Ensure that the
socket outlet is installed near the product.
WARNING:
To avoid electrical shock, connect the three-prong plug on this product to an
earth-grounded three-pin socket outlet only.
4038938 Rev A
Item
D9054 HDTV Encoder Installation and Operation Guide
Specification
IEC 320 style C14 appliance receptable (one
per power supply)
100 to 240 V AC, 50/60 Hz ± 10%
500 W
5A total, 2.5A per power supply maximum
ANSI/IEEE Std C62.41.1-2002
A-9