Cisco D9054 Installation And Operation Manual page 121

Monitoring Statistical Multiplexing,
DSP Comm Error Count
These are the number of communication errors which have occurred within the
encoder since the error count was reset (via Reset Local Statistic operation), for each
of the encoders in the statmux pool that the local encoder belongs to. These types of
errors are local communication errors on the statmux data path within the encoder.
Network Comm Error Count
This is the number of network communication errors which have occurred since the
encoders were powered up or reset for each of the encoders in the statmux pool that
the local encoder belongs to. Network communication errors are initiated when an
error in communication exist between the local encoder and any of the encoders in
the same statmux pool. It is expected that network communications errors may
occur is some instances during encoder power up but should not increment once
fully powered up.
Note: Network communication errors can be cleared for the local encoder by
clicking Reset Local Statistic at the bottom of the page. For more information, see To
Reset the Local Statistic, page 5-38.
Primary Encoder List/ Secondary Encoder List
System Name
These are the unique system names for each of the encoders in the statmux pool. See
Reading the System Information or Managing the System, page 5-120 for more
information.
Service PID
These are the unique PID numbers assigned to each of the services output by the
encoders in the statmux pool.
Redundancy
This is the operating state of each of the encoder in the statmux pool, either Active
or Standby.
Algorithm ID
These are the algorithm IDs assigned to each of the encoders in the statmux pool.
4038938 Rev A
Continued
D9054 HDTV Encoder Intstallation and Operation Guide 5-37