Connecting To An Electrical Power Source - Cisco 2000 User Manual

• IP network and/or Internet connection
• A streaming media server for streaming your content to many viewers

Connecting to an Electrical Power Source

Plug the power cable provided with your encoder to the block end of the power unit located on the
upper corner on the rear panel of the encoder.
Plug the other end into a wall outlet or surge protection enabled power strip that is connected to wall
outlet or other common power source.
The plug-socket combination must be accessible at all times, because it serves
Warning
as the main disconnecting device.
Do not work on the system or connect or disconnect cables during periods of
Warning
lightning activity.
Cisco Digital Media Encoder 2000 Rear Panel Diagram
The diagram and table below illustrates all of the connectors and other components of the Cisco
Digital Media Encoder 2000 rear panel.
The diagram above shows the rear panel of the Cisco Digital Media Encoder 2000. The Analog
Input section of the rear panel is used to connect your audio and video source to the Cisco Digital
Media Encoder 2000.
Using the reference chart and images below, you can connect the appropriate device and power to
the Cisco Digital Media Encoder 2000.
-12-
I G
NSTALLATION UIDE