Connecting The Ethernet Management Interface - Cisco D9054 Installation And Operation Manual

Connecting the Ethernet Management Interface

The Ethernet Interface
The RJ-45 interface for 10/100 BASE-T Ethernet is intended for management via the
ROSA control management system.
Hint: If you experience problems with the 10 BASE-T Ethernet it is advised that
you change it to a 100 BASE-T connection.
Note: You must set up the IP address, the default gateway and the subnet mask to
match the network connection. This is done through the front panel menu. For
further information, see Front Panel Setup, page 1-3.
Pin Allocation, Ethernet Connector
The table shows the Ethernet connector and the pin allocation (MDI interface)
Connector
1
Informative Notes
Proper cables are required for reliable Ethernet operation; to run over a maximum
segment length of 100 m the cable has to comply with the EIA/TIA Category 5 wire
specifications. The cable must be shielded to ensure compliance with EMC
requirements.
To Connect the Ethernet Interface
1. Connect a crossed RJ-45 cable between the Ethernet connector on the D9054 HD
Encoder and the Ethernet port of your PC.
Note: You need a crossover cable if you want to connect the Ethernet interface of
the D9054 HD Encoder directly to another Ethernet device without using a hub or
switch.
You need to set up the IP address on both the D9054 HD Encoder (via the front
panel display) or the ROSA driver for D9054 HD Encoder. For information on
setting up the IP address via the front panel, see Front Panel Setup, page 1-3.
4038938 Rev A
Pin
1 Tx+
2 Tx-
3 Rx+
4 Not connected
5 Not connected
8
6 Rx-
00-052
7 Not connected
8 Not connected
D9054 HDTV Encoder Intstallation and Operation Guide
Pin Allocation
:
3-11