Cisco D9054 Installation And Operation Manual page 154

Setting Up the AAC Audio Input,
The following table outlines the input selections, depending on the Mode and
Input Type selected (for encoders equipped with a Multiple Channel Audio
(MCA) card only):
Stereo 2/0, Dual
Mono 1+1, Mono
(Center) 1/0, Single
Mono 1/0, or Joint
Stereo 2/0
3/2 (L,R,C,Ls,Rs)
5-70
Continued
Mode Input Type
Digital
Embedded
Dolby-E Decoder
Note: Only available for
encoders equipped with a
Multiple Channel Audio (MCA)
card that is equipped with a
Dolby Advanced Sub-Module
(DASM) and a Dolby-E
Decoder license.
Digital
Embedded
Dolby-E Decoder
D9054 HDTV Encoder Intstallation and Operation Guide
Input Selections
L,R for Digital Input
L,R for Embedded Input
The HD-SDI video input can contain up to 8
stereo audio channels each represented by a
packet 1 to 4 and pair 1 or 2. You can transfer up
to 2 of these channels.
L,R for Dolby-E Decoder Input
(L,R), (C,LFE), and (Ls,Rs) for Digital Input
(L,R), (C,LFE), and (Ls,Rs) for Embedded Input
(L,R), (C,LFE), and (Ls,Rs) for Dolby-E Decoder
Input
4038938 Rev A