Setting Up The Linear Audio Program - Cisco D9054 Installation And Operation Manual

Setting Up the Linear Audio Program

To Set Up the Linear Audio Program
Proceed as follows to set up the Linear Audio Program:
1. From the user interface of the D9050 Encoder click the PSI tab, expand the
Audio icon, expand the Linear/Dolby-E icon and click one of the channel icons
from the sub-pages
Note: The number of channels displayed depends on whether your encoder is
equipped with a Dual Channel Audio (DCA) card or a Multiple Channel Audio
(MCA) card. MCA cards provide six configurable audio channels, allowing you
to configure Ch 1 (Audio 1) through Ch 6 (Audio 6).
2. Type the audio PID.
The legal range is from 16 to 8190
for any other program element.
3. If relevant, Enable the PCR.
Important: An audio only program consisting of one or more audio tributaries
must have at least one PCR PID enabled. If the audio is attached to the Video it
does not need a PCR PID.
4. Type the audio Language.
You must type in three letters. The supported languages are according to ISO
639-2. The audio language is signalled in a PSI table and used by satellite
receivers.
1)Note that the DVB tables use the PIDs from 16 to 20.
5-114 D9054 HDTV Encoder Intstallation and Operation Guide
1)
. Observe that you may not use the same PID
4038938 Rev A