Setting Up the Transport Stream
To Set Up the Transport Stream
Proceed as follows to set up the Transport Stream:
1. From the user interface of the D9054 HD Encoder, click the PSI tab and the
Transport Stream icon from the sub-pages.
2. Type the Network ID.
The range is from 0 to 65535.
3. Type the Original Network ID.
Note: If the NIT is transmitted on the network on which the TS was originated,
the network ID and the original network ID have to be identical.
4. If required, change the Transport Stream ID.
You may enter a value between 1 and 65535. You may enter the ID as a decimal
figure.
5. Type the Network Name.
You may type alphanumeric characters. Up to 30 characters are allowed. The
supported character set is ASCII.
6. Click Apply.
5-104
D9054 HDTV Encoder Intstallation and Operation Guide
4038938 Rev A