Cisco D9054 Installation And Operation Manual page 39

Control and Management Interfaces,
Ethernet
The main control interface for the D9054 HD Encoder is the 10/100 BaseT Ethernet
interface.
You can set up and control the D9054 HD Encoder via the Ethernet connection
using SNMP and a management system, for example the ROSA Network
Management system or the Web-based GUI.
From ROSA you can update the D9054 HD Encoder software using FTP (File
Transfer Protocol).
A MIB file is included in the delivery from Cisco for the D9054 HD Encoder to
support 3
Alarm Relay Interface
During operation the condition of the D9054 HD Encoder can be monitored by three
relay contact outputs, accessible from the Alarm connector on the rear panel of the
D9054 HD Encoder. Furthermore, the alarm status is signalled by Alarm LEDs on
the front of the D9054 HD Encoder and by messages sent via the management
system.
4038938 Rev A
rd
party SNMP managers when the ROSA System is not utilized.
D9054 HDTV Encoder Intstallation and Operation Guide
Continued
2-11