Cisco D9054 Installation And Operation Manual page 241

Message Description and Remedy
Linear/Dolby E: Description: Incoming packets were not
Passthrough PTS processed in time resulting in data being
error dropped.
Remedy: Check the expected maximum
passthrough rate and configure the audio
channel for the worst case input bit rate.
Description: The audio delay setup on the
Linear/Dolby E:
Audio DSP is too low.
Requested audio
encoding delay Remedy: Increase the audio delay.
set too low
Description: The audio delay setup on the
Linear/Dolby E:
Audio DSP is too high.
Requested audio
encoding delay Remedy: Decrease the audio delay.
set too high
Linear/Dolby E: Description: Passthrough data corrupted
Passthrough data missing.
invalid
Remedy: Check the passthrough input.
Linear/Dolby E: Description: The requested PCR rate can
PCR rate not not be achieved.
achievable
Remedy: No action possible.
Linear/Dolby E: Description: The audio delay setup on the
Board Delay too Audio DSP is too high.
high
Remedy: Decrease the audio delay.
Linear/Dolby E: Description: The incoming Data Rate on
Passthrough passthrough is too low.
input rate lower
Remedy: Increase the selected bit rate.
than requested
output rate
Description: Passthrough input is
Linear/Dolby E:
missing.
Passthrough
enabled but no Remedy: Apply passthrough signal.
sync words
Description: The passthrough input
Linear/Dolby E:
header is corrupted or invalid.
Passthrough
header corrupted Remedy: Correct the passthrough input
or invalid header.
4038938 Rev A D9054 HDTV Encoder Intstallation and Operation Guide
Severity Default
Alarm
Category
Minor B
Major B
Minor None
Major A
Minor B
Major A
Major A
Major B
Major B
Enable
On
On
On
On
On
On
On
On
On
6-19