Cisco D9054 Installation And Operation Manual page 79

System Menu,
Continued
IP, Mask
Parameters:
Description:
IP, Gateway
Parameters:
Description:
IP, Speed/Duplex
Parameters:
Description:
Reset
Parameters:
Description:
4038938 Rev A
<0 to 255>.<0 to 255>.<0 to 255>.<0 to 255>.
The subnet mask of the management interface to the D9054 HD
Encoder. Similar to the IP Address above.
Note: The subnet mask is not affected by the Default command.
<0 to 255>.<0 to 255>.<0 to 255>.<0 to 255>.
The default gateway of the management interface to D9054 HD
Encoder. The D9054 HD Encoder uses this gateway to route IP
traffic across the network. Similar to the IP Address above.
Note: The default gateway setting is not affected by the Default
command.
Hint: The default gateway 0.0.0.0 means that no gateway is used.
Auto Negotiation (default), 10 Mbps Half/Full Duplex, or 100 Mbps
Half/Full Duplex.
Displays the speed/duplex of the management interface to the
D9054 HD Encoder.
N/A.
Resets (boots) the D9054 HD Encoder.
The D9054 HD Encoder displays a message asking you to confirm
the resetting of the unit. Press SELECT to reset and UP or PREV to
leave the menu without resetting.
Hint: You should reset the D9054 HD Encoder in the following
cases:
• If there has been a temperature alarm causing the D9054 HD
Encoder to disable functionality.
• If you have set or changed the IP address, subnet mask or
gateway of one of the IP interfaces of the D9054 HD Encoder via
the front panel display.
Note: The reset may take up to 90 seconds.
D9054 HDTV Encoder Intstallation and Operation Guide 4-25